Desk Mounting (Gs1920-8Hpv2 Only); Installation Requirements - ZyXEL Communications GS1920v2 Series User Manual

Attach the rubber feet to each corner on the bottom of the Switch. These rubber feet help protect the
3
Switch from shock or vibration and ensure space between devices when stacking.
Note: Rubber feet will be attached to the GS1920-8HPv2 by default. To make sure of air
circulation, do NOT remove them.
Attaching Rubber Feet
Fig ure 5
Set the Switch on a smooth, level surface strong enough to support the weight of the Switch and the
4
connected cables. Make sure there is a power outlet nearby.
Make sure there is at least 40 mm of clearance around and from the surface to the bottom of the Switch
5
to allow air circulation and the attachment of cables and the power cord.
Note: Make sure that you meet the requirements of clearance when you use the Switch for
stacking. It's recommended to only use the Switch with Fans in a stack. See
page 20
WARNING ! Do NO T b lo c k the ve ntila tio n ho le s no r sto re thing s o n the
Switc h. Allo w c le a ra nc e fo r the ve ntila tio n ho le s to pre ve nt yo ur Switc h
fro m o ve rhe a ting . T his is e spe c ia lly c ruc ia l whe n yo ur Switc h do e sn't
ha ve fa ns. O ve rhe a ting c o uld a ffe c t the pe rfo rm a nc e o f yo ur Switc h, o r
e ve n da m a g e it.
2.3 De sk Mo unting (G S1920- 8HPv2 O nly)
The GS1920-8HPv2 can be mounted under a table. Follow the steps below to mount your Switch under a
table.
2.3.1 Insta lla tio n Re q uire m e nts
• Two mounting brackets
• Eight M3 flat head screws and a #2 Philips screwdriver
• Four M4 flat head screws and a #2 Philips screwdriver
• Four washers (inside diameter: 3.5mm; outside diameter: 11.5mm)
Chapter 2 Hardware Installation and Connection
to see whether your Switch has fans.
GS1920v2 Series User's Guide
29
Table 1 on