Step 1. Connect the emulator probe to the demo
target system
1 With HP 64700 power OFF, connect the emulator probe to the demo target system. When you install
the probe into the demo board, be careful not to bend any of the pins. Do not insert the probe of the
MC6833x emulator into the demo board socket incorrectly. Be very careful.
Note that pin 1 is located in the center of the line closest to the plastic cover on the MC68331, MC68332,
and MC68334 emulator probes. Pin A1 is located in the corner (indicated by the dot on the PGA socket)
on the edge furthest from the plastic cover on the MC68336 and MC68338 emulator probes. Correct
orientation of the probe and demo board is shown below for all MC6833x emulator probes.
Chapter 3: Connecting to the Demo Board
Installation
45