Step 1. Connect The Hp 64700 To A Pc Host Computer - HP 64782 Series Manual

Chapter 5: Installing/Updating Emulator Firmware
Updating the firmware using a PC
Step 1. Connect the HP 64700 to a PC host
computer
1 Make a note of the present settings of the data communications configuration switches on the
HP 64700 card cage. These switches are labeled "COMM CONFIG" (communications configuration).
You may want to restore these switch settings after you finish updating the firmware.
Set the COMM CONFIG switches to the zero or open position, as shown in the illustration. These
switches establish communication over the RS-232 at 9600 baud. Switch 16 is the LAN/RS-232 switch.
Note that switch settings are read during the power up routine of the HP 64700 card cage. Any changes
made to the switches after power-up will not be read until you turn the HP 64700 off and back on again.
94