HP 64782 Series Manual page 51

To configure LAN parameters using the terminal interface
set to the address of the gateway machine. The gateway
address must be obtained from your local system administrator.
-s <subnet> The Subnet Mask (in integer dot notation) is optional and only
available when using the HP 64700A. It defaults to 0.0.0.0.
The default is valid only on networks that are not subnetted. (A
network is subnetted if the host portion of the Internet address
is further partitioned into a subnet portion and a host portion.)
If the network is subnetted, a subnet mask is required in order
for the emulator to work correctly. The subnet mask should be
set to all "1"s in the bits which correspond to the network and
subnet portions of the Internet address and all "0"s for the host
portion. The subnet mask must be obtained from your system
administrator.
-p <port> This changes the base TCP service port number. The host
computer interfaces communicate with the emulator through
two TCP service ports. The default base port number is 6470.
The second port has the next higher number (default 6471). If
you change the base port, the new value must also be entered in
the /etc/services file on the host computer. For example, you
could modify the line:
hp64700 6470/tcp
The default numbers (6470, 6471) can be changed if they
conflict with some other product on your network. TCP service
port numbers must be greater than 1024.
For example, to assign an Internet Address of 192.6.94.2 to the emulator, enter the
following command:
R>lan -i 192.6.94.2 <RETURN>
The Internet Address and any other LAN parameters you change are stored in
nonvolatile memory and will take effect the next time the emulator is powered off
and back on again.
6 Turn power to the emulator OFF, and connect the the emulator to your network.
This connection can be made by using either the 15 Pin AUI connector or the BNC
connector.
Chapter 2: Connecting to a Host Computer
39