Table of Contents
Advertisement
Chapter 1: Preparing the Emulator
Step 1. Install optional memory modules on Deep Analyzer card (if using the Deep
2 To ensure correct installation of optional memory modules on the deep analyzer card, there is a cutout
at one end of the memory modules so they can only be installed the correct way.
To install a memory module:
Align the groove in the memory module with the alignment rib in the connector.
Align the cutout in the memory module with the projection in the connector.
Place the memory module into the connector groove at an angle.
Firmly press the memory module into the connector and make sure it is completely seated.
Rotate the memory module forward so that the pegs on the connector fit into the holes on the memory
module.
Make sure the release tabs at each end of the connector snap around the memory module to hold it in
place.
8
Advertisement
Table of Contents
