Table of Contents
Advertisement
Chapter 1: Preparing the Emulator
Step 3. Install Boards into the HP 64700 Card Cage
10 Install the analyzer and emulation control cards. The analyzer is installed in the slot next to the
system control card. The emulation control card is installed in the second slot from the bottom of the
card cage. The software performance analyzer card may occupy any slot between the emulation-bus
analyzer and the emulation control card. These cards are identified with labels that show their model
numbers and serial numbers. Note that components on the analyzer card face the opposite direction to
the other cards.
To install a card, insert it into the plastic guides. Make sure the connectors are properly aligned; then,
press the card into the mother board socket. Ensure that each card is seated all the way into its socket. If
the cards can be removed with your fingers, the cards are NOT seated all the way into the mother board
sockets.
Attach the ribbon cable from the emulation control card to the analyzer card, and to the software
performance analyzer, if installed. Tighten the thumbscrews that hold the emulation control card to the
cardcage frame.
18
Advertisement
Table of Contents
