Step 3. Verify The Performance Of The Emulator - HP 64782 Series Manual

Chapter 3: Connecting to the Demo Board
Installation

Step 3. Verify the performance of the emulator

1 Establish communication with the emulator from your host or ASCII terminal and
obtain a prompt (such as R>).
2 Enter: pv 1 <return>
The emulator will print the results of its test, followed by a prompt.
3 Enter: ver <return>
The emulator will print some version numbers and the status of the memory
modules on the probe, followed by a prompt.
4 Enter: <CTRL>d
This command will end the emulation session.
5 If the emulator reported any failures, refer to Chapter 6.
Examples
If you are using a LAN, you can use the telnet capability with the built-in Terminal
Interface:
Note: the HP 64700 telnet capability is not supported by Hewlett-Packard.
Performance verification is discussed in detail in Chapter 8.
48
1 From your host computer enter the command: telnet <emulator_name>.
2 Now enter the command: pv 1