To View Help On Individual Commands - HP 64782 Series Manual

The emulator will list the emulation commands:
emul - emulation commands
-----------------------------------------------------------------------------
b......break to monitor
bc.....break condition
bp.....breakpoints
cf.....configuration
cim....copy target image io.....input/output
ck.....check config
cmb....CMB interaction
cov....coverage

To view help on individual commands

• To display help information for a particular command, type: help
<command_name>
The emulator will display the command syntax, description, and examples.
Examples
To display help information for the processor step command, enter:
R>help s
The emulator will display:
s - step emulation processor
s
s <count>
s <count> $
s <count> <addr>
s -q <count> <addr>
s -w <count> <addr>
--- NOTES ---
STEPCOUNT MUST BE SPECIFIED IF ADDRESS IS SPECIFIED!
If <addr> is not specified, default is to step from current PC.
A <count> of 0 implies step forever.
cp.....copy memory
dump...dump memory
es.....emulation status
info...config info
load...load memory
m......memory
map....memory mapper
- step one from current PC
- step <count> from current PC
- step <count> from current PC
- step <count> from <addr>
- step <count> from <addr>, quiet mode
- step <count> from <addr>, whisper mode
Chapter 8: Using the Terminal Interface
To view help on individual commands
mo.....modes
r......run user code
reg....registers
rst....reset
rx.....run at CMB execute
s......step
ser....search memory
sync...sync sim and ems
127