Table of Contents
Advertisement
• Make sure no error code appears on the LCD display. For more on error codes,
refer to "Error Code List" in the appendix of the separate "AIT Library:
Operating Instructions".
• Make sure to wait at least 10 seconds before turning the power back on after
turning it off.
• Make sure to hold down the STANDBY button for at least 3 seconds. To
prevent mistaken operation, the unit is designed not to turn on unless the
STANDBY button is held down for at least 3 seconds.
• If a network cable is connected, try disconnecting it.
Cannot access the AIT library
• Make sure the SCSI IDs assigned to the library, AIT drive, and main server
do not overlap. You cannot set overlapping SCSI IDs on a single SCSI bus.
Refer to "Setting the SCSI ID" in Chapter 2, "Installation" of the separate "
AIT Library: Operating Instructions".
• Make sure the SCSI cable is connected properly.
• Make sure the SCSI bus is terminated correctly. Refer to "About SCSI Bus"
in the appendix of the separate "AIT Library: Operating Instructions".
• Make sure the application software being used is compatible with this system.
For more on application software that can be used with this system and
compatible operating systems, contact your dealer.
Cannot read data or write data, even though the
application software and AIT library are operating
correctly.
• Make sure the cartridges' erase-protection tab is set to the write-enable
position. Refer to "Replacing the Cartridges" in Chapter 4,"Operating the AIT
Library" of the separate "AIT Library: Operating Instructions".
• Make sure to use Sony-manufactured AIT cartridges. Also, check to make
sure the cartridges you are using are compatible with the AIT drive (page 6).
• If the cartridge has been used for a long time or with high frequency, you need
to replace it with a new cartridge. Contact your dealer.
• Make sure the cartridge tape has not broken.
• Try cleaning the AIT drive. Refer to "Cleaning the AIT Drive" in Chapter 5,
"Operating the AIT Drive" of the separate "AIT Library: Operating
Instructions".
Cannot eject AIT cartridges
Perform the operation described in "Taking Out the Cartridges" in Chapter 4,
"Operating the AIT Library" of the separate " AIT Library: Operating
Instructions". If you still cannot eject cartridges, consult the dealer you
purchased your equipment from.
Other problems (AIT library)
• Make sure the shutter covering the cartridge dock is firmly closed.
• Try running a diagnostic check on the library. Refer to "Diagnostic" in
Chapter 6, "Using the Library Administration Menu" of the separate "AIT
Library: Operating Instructions".
73
Appendix
Advertisement
Table of Contents
