Sony StorStation FSV-VN5 Administrator's Manual page 29

• Nightly : This address receives a nightly report of maintenance results.
• Alert : This address receives a report of error messages that have
occurred during operation.
• History : This address receives a report of the tape volume names on
which the latest system backups were performed. (You may
also indicate the hour and minute when this report is sent.)
• Test mail function:
When you click the [Test transmission], a test message is sent
to the specified e-mail address.
Before performing a test transmission, save the settings.
Caution
Be sure to set an e-mail address for the [History] report, because it includes
information necessary for system recovery.
Note
The addresses designated here will receive the three types of e-mail below.
E-mail subject line
[S] PetaServe Maintenance
Report<<<SUCCESS>>>
PetaBack histories Report
PetaServe alert messages --
Including Urgent Messages!
PetaServe alert Messages --
Including Warnings
Tape migration policy
You can set requirements for migrating files from the hard disks to the AIT
cartridges.
• Last access time: Set the maximum number of days from the last time a file
was accessed (the atime attribute of UNIX files). Files that are not accessed
for longer than this are targeted for migration to AIT cartridge.
• Size: Input in units of KB. Files over this limit are targeted for migration to
AIT cartridge. Input a value larger than that of the stub file size (see below).
• Stub file size: Input in 4KB units. The value set here becomes the actual size
of the stub file that remains on the main server when the original file is
migrated to AIT cartridge. It will not affect the size of files stored only on the
main server.
Misc. configuration
• PetaServe API: Selecting this box, activates the PetaServe API (Application
Program Interface).
PetaServe API may be required when connecting to the application server. For
more details, contact your dealer.
• HNF OFM: Selecting this box activates the offline volume management
function. You can then use the OFM (OFfline volume Management) function
to eject a volume from a library, which enables you to use more volumes than
the capacity of a library.
Content
The part enclosed by <<< >>> has the following
meanings.
SUCCESS: Completed successfully
FAILURE: Unsuccessful
WARNING: Warning
There is no need to check the content of this
report, but because the most recent report is
necessary when performing a system restore, you
should save the latest two weeks' reports.
Indicates that an alert message has been created.
Chapter 3 Using the Web Administration Screen
28