Enable Hose Manual Mode; Disable Hose Manual Mode - Graco Reactor 2 H-30 Operation

Spraying
Enable Hose Hose Manual Manual Mode
Enable Enable Hose Manual
1. Enter Setup Mode and navigate to System
screen 3.
2. Set the Hose Control Mode to Manual.
NOTE: When manual hose mode is enabled, the
NOTE: NOTE:
manual hose mode advisory EVCH-V will appear.
3. Enter Run Mode and navigate to the Targets
screen. Use the up and down arrows to set the
desired hose current.
56
Mode
Mode
Hose Current Current Settings Settings Hose
Hose Hose Current Settings
Default
Maximum
4. Navigate back to the Run Mode Home screen.
The hose now displays a current instead of a
temperature.
NOTE: Until the RTD sensor is repaired, the
NOTE: NOTE:
T6DH sensor error alarm will display each time
the system is powered up.
Disable Hose Disable Disable Hose Manual Hose Manual Mode Manual
1. Enter Setup Mode.
2. Navigate to System screen 3.
3. Set the Hose Control Mode to FTS or Resistance.
Hose Current Current
Hose Current
20A
37A
Mode Mode
334945J