Advanced Display Module (Adm); Operation - Graco Reactor 2 H-30 Operation

Advanced Display Module (ADM) Operation
Advanced Display Display Module
Advanced Advanced Display
When main power is turned on by turning the main
power switch (MP) to the ON position, the power up
screen will be displayed until communication and
initialization is complete.
Then the power key icon screen will display until the
ADM power on/off button
time after system power-up.
To begin using the ADM, the machine must be
active. To verify the machine is active, verify that the
System Status Indicator Light is illuminated green,
see Advanced Display Module (ADM), page
System Status Indicator Light is not green, press the
ADM Power On/Off button
Indicator Light will illuminate yellow if the machine
is disabled.
34
Module (ADM)
Module
is pressed for the first
22. If the
. The System Status
(ADM) Operation

Operation

(ADM) Operation
If Hose Resistance Mode is enabled, a reminder
prompt will appear when the ADM becomes active.
Press the Continue soft key
Perform the following tasks to fully setup your system.
1. Set pressure values for the Pressure Imbalance
Alarm to activate. See
2. Enter, enable, or disable recipes. See
Recipes Screen, page
3. Set general system settings. See
Advanced Screen 1 — General, page
4. Set units of measure. See
Advanced Screen 2 — Units, page
5. Set USB settings.
Advanced Screen 3— USB, page
6. Set target temperatures and pressure. See
Targets, page 42.
7. Set component A and component B supply
levels. See Maintenance, page
to clear the screen.
System Screen 1, page
39.
37.
37.
See
37.
42.
334945J
38.