Installation; Assemble The Proportioner; Mounting The System - Graco Reactor 2 H-30 Operation

Installation

Installation
Installation Installation
Assemble the the Proportioner Proportioner
Assemble Assemble the Proportioner
Reactor 2 proportioners arrive in a shipping
configuration. Before mounting the system, assemble
the proportioner in the upright position.
1. Remove bolts (A) and nuts.
2. Swing the electrical enclosure upright.
3. Reinstall bolt (A) with nut. Tighten bolt (B) and
nut.
4. Position the cable bundles against the frame.
Attach the bundles to the frame with a loose wire
tie (C) on each side.
30
Mounting the the System System
Mounting Mounting the System
To prevent serious injury due to system tipping
over, make sure the Reactor is secured to the floor.
NOTE: Wall mounting brackets are not included with NOTE: NOTE:
the system. Evaluate the installation to determine
if additional support is required beyond the floor
mounting screws.
1. See Dimensions, page 74
specifications.
2. Use a minimum of 4 of the 6 mounting holes,
evenly spaced in the base of the system frame,
to secure base to the floor.
NOTE: NOTE: Bolts are not included. NOTE:
for mounting hole
334945J