System 1; System 2; System 3; System 4 - Graco Reactor 2 H-30 Operation

Advanced Display Module (ADM) Operation

System 1 1 1

System System
Use this screen to enable pressure imbalance alarms
and deviations, set pressure imbalance values,
enable inlet sensors, and enable low chemical
alarms.
Select accessories using this screen. If the flow
meter accessory is installed, use this screen to:
• Enable ratio errors
• Set the ratio alarm percentage
NOTE: NOTE: NOTE: Reactor Smart Control is not available for
Reactor 2 Hydraulic systems.

System 2 2 2

System System
Use this screen to enable Integrated Mode and the
diagnostic screen. This screen can also be used to
set the primary heater size and the maximum drum
volume.
Integrated Mode allows the Reactor 2 to control
an Integrated PowerStation, if the Integrated
PowerStation is installed. If the flow meter accessory
is installed, use this screen to set the k-factors.
K-factors are printed on the flow meter serial number
labels.
38

System 3 3 3

System System
Use this screen to select Hose Control
Mode and perform calibration. See
Hose Control Modes, page 54
on the different hose control modes. Hose
Resistance Mode can only be used if a calibration
factor is stored. See Calibration Procedure, page

System 4 4 4

System System
Use this screen to enable alternate pump cylinder
sizes, to turn motor standby mode on and off, and to
enable recirculation cycle count. Cycles below 700
psi (4.82 MPa, 48.2 Bar) outlet pressure will not be
counted unless enabled.
for information
57.
334945J