Standby - Graco Reactor 2 H-30 Operation

Spraying
4. Accept or cancel the hose calibration.
NOTE: A temperature estimate will be displayed
NOTE: NOTE:
if the system was able to measure the hose wire
resistance.

Standby

Standby Standby
If you stop spraying for a period of time, the unit will
enter standby by shutting down the electric motor
and hydraulic pump, to reduce equipment wear and
minimize heat buildup. The pump icon on the ADM
Home screen will flash when in standby.
NOTE: The A, B, and Hose heat zones will not shut
NOTE: NOTE:
off during standby.
To restart, spray off target for two seconds. The
system will sense the pressure drop and the motor
will ramp up to full speed in a few seconds.
58
NOTE: This feature is disabled from the factory.
NOTE: NOTE:
To activate or deactivate standby:
1. Enter setup mode by pressing
2. Go to screen System 3 and select to
the page for editing.
3. Select the "Standby Idle Time" drop-down using
and the arrow keys. Select the desired delay
using and the arrow keys. Press enter to
select the desired value.
4. Exit the page and return to run mode by pressing
, then .
on the ADM.
enter
334945J