System Control Drawing 16P577 - Graco ProMix PD2K Installation Manual

System Control Control Drawing
System System Control
Do not substitute or modify system components
as this may impair intrinsic safety. For installation,
maintenance, or operation instructions, read
instruction manuals. Do not install equipment
approved only for non-hazardous location in a
hazardous location. See the identification label for
the intrinsic safety rating for your model.
NOTES NOTES FOR NOTES FOR FOR SYSTEM SYSTEM CONTROL SYSTEM
CERTIFICATE)
CERTIFICATE) CERTIFICATE)
2. The non-intrinsically safe terminals (power rail) must not be connected to any device which uses or
generates more than Um = 250 Vrms or dc unless it has been determined that the voltage has been
adequately isolated.
3. The electrical enclosure ground screw must be connected to a true earth ground using the supplied
ground strap (223547) or by an equivalent 10 AWG or larger isolated conductor. Resistance from the
electrical enclosure ground to the true earth ground shall not exceed 1 ohm.
4. Multiple earthing of components is allowed. Intrinsically safe apparatus provides isolation from earth to
500 Vrms.
Do not operate system with power barrier cover removed.
6. Installation should be in accordance with ANSI/ISA RP12.06.01 "Installation of Intrinsically Safe Systems
for Hazardous (Classified) Locations" and the National Electrical Code® (ANSI/NFPA 70).
7. Installation in Canada should be in accordance with the Canadian Electrical Code, CAS C22.1, Part I,
Appendix F.
8. For ATEX, install per EN 60079–14 and applicable local and national codes.
9. For IECEx install per IEC 60079–14 and applicable local and national codes.
332458M
Drawing 16P577
Drawing
CONTROL DRAWING CONTROL DRAWING 16P577 DRAWING
Alternate M12 Alternate Alternate
Cable Part Part No.
Cable Cable Part
16V423
16V424
16V425
16V426
16V427
16V428
16V429
16V430
16P577
16P577
16P577 (FM13ATEX0026 16P577 (FM13ATEX0026 SYSTEM (FM13ATEX0026
M12 CAN M12 CAN CAN Cables, Cables, for Cables, for Hazardous for Hazardous Locations Hazardous
No.
No.

System Control Drawing 16P577

SYSTEM ASSEMBLY SYSTEM ASSEMBLY ASSEMBLY
Locations Locations
Length ft ft ft (m) (m)
Length Length (m)
2.0 (0.6)
3.0 (1.0)
6.0 (2.0)
10.0 (3.0)
15.0 (5.0)
25.0 (8.0)
50.0 (16.0)
100.0 (32.0)
11