Bravo Two Models - Mercury Sterndrive QSD 2.0 Manual

3. Torque the propeller nut.
a
b
NOTE: The propeller torque stated is a minimum torque value.
Description
Bravo One propeller nut
4. Models equipped with the tab washer: Continue to tighten the propeller nut until the three tabs on the tab washer align
with the grooves on the spline washer.
5. Bend the three tabs down into the grooves.
b
a

Bravo Two Models

IMPORTANT: Use the correct rotation propeller. The propeller rotation MUST match the direction of rotation of the propeller
shaft.
1. Liberally coat the propeller shaft spline with one of the following Quicksilver lubricants.
Tube Ref No.
Special Lubricant 101
34
2-4-C Marine Lubricant
95
with PTFE
Anti-Corrosion Grease
94
NOTE: Anti‑corrosion grease is for saltwater applications only.
2. Install the propeller with the attaching hardware as shown.
90-8M0069751 APRIL 2012
eng
d
c
c
a - Prop
b - Tab washer
d
c - Drive sleeve adapter
d - Tab bent down
e
e - Propeller nut
4750
Description
Typical Bravo One models
a - Propeller shaft splines
b - Forward thrust hub
c - Flo‑Torque II drive hub
d - Propeller
e - Drive sleeve adapter
f
e
f - Tab washer
g
g - Propeller nut
5301
Where Used
Propeller shaft splines
Propeller shaft splines
Propeller shaft splines
Section 5 - Maintenance
Nm lb–in. lb–ft
75 –
Then align tabs with grooves
Part No.
92-802865Q02
92-802859A 1
92-802867Q 1
Page 103
55