Table of Contents
Advertisement
Section 5 - Maintenance
IMPORTANT: If fluid is not visible in the fluid reservoir, see your Mercury Diesel authorized repair facility.
Filling
1.
Remove the fill cap and dipstick and observe the fluid level.
2.
Add the specified fluid to bring the fluid level up to the proper level.
Tube Ref No.
Power Trim and Steering
114
Fluid
Dexron III Automatic
28
Transmission Fluid
3.
Install the fill cap and dipstick.
Changing
Power‑assisted steering fluid does not require changing unless it becomes contaminated. See your Mercury Diesel authorized
repair facility.
Engine Coolant
A sudden loss of pressure can cause hot coolant to boil and discharge violently resulting in serious injury from burns. Allow
the engine to cool down before removing the coolant pressure cap.
Checking
IMPORTANT: Check the engine coolant before starting the engine.
1.
Allow the engine to cool.
2.
Remove the pressure cap from the coolant expansion tank.
3.
The coolant level in the coolant expansion tank should be within 25 mm (1 in.) of the top of the fill neck.
b
a
4.
If the coolant level is low:
a.
Inspect the coolant recovery system for leaks.
Page 62
Description
!
Where Used
Power-assisted steering pump
Power-assisted steering system
CAUTION
c
25356
Part No.
92-858074K01
Obtain Locally
Location of engine coolant cap
(engine cover removed)
a -
Pressure cap
b -
Coolant expansion tank
c -
Bottom of fill neck
90-8M0069751
APRIL 2012
eng
Advertisement
Table of Contents
