Table of Contents
Advertisement
3.
Ensure that the rubber gasket is inside the gear lube monitor cap and install the cap. Do not overtighten.
a
NOTE: When filling the entire sterndrive, see Changing .
Changing
1.
Remove the gear lube monitor from the bracket.
a
2.
Empty the contents of the gear lube monitor into a suitable container.
3.
Install the gear lube monitor in the bracket.
4.
Remove the propeller. See Propellers.
5.
Bravo One Models:
a.
Lower the sterndrive to the full down position.
b.
Remove the gear lube fill and drain plug and sealing washer.
c.
Drain the gear lube into a suitable container
a
b
6.
Bravo Two models and Bravo Three models:
a.
Raise the sterndrive to the full up position.
b.
Remove the fill and drain plug and sealing washer.
90-8M0069751
APRIL 2012
eng
a -
Gear lube monitor cap
19962
b
mc79506-1
a -
Gear lube monitor bracket
b -
Gear lube monitor and cap
c -
Retaining strap
c
5500
a -
Fill and drain plug
b -
Sealing washer
Section 5 - Maintenance
Page 57
Advertisement
Table of Contents
