Power Trim Fluid; Checking; Filling - Mercury Sterndrive QSD 2.0 Manual

Section 5 - Maintenance
Description
Fill and drain plug
16. Install the sterndrive propeller. See Propellers.
17. Recheck the gear lube level at the gear lube monitor after the first use. See Checking.
IMPORTANT: The gear lube level in the gear lube monitor will rise and fall during sterndrive operation; always check the gear
lube level when the sterndrive is cool and the engine is shut down.

Power Trim Fluid

Checking

IMPORTANT: Check the fluid level with the sterndrive in the full down (in) position only.
1. Place the sterndrive in full down (in) position.
2. Observe the fluid level. The fluid level must be between the "MIN" and "MAX" lines on the reservoir.
a
a - Reservoir
b - "MIN" and "MAX" lines
3.
Fill as necessary with the specified fluid. See Filling.
Tube Ref No.
Power Trim and Steering
114
Fluid

Filling

1. If the fluid level is below the "MIN" line, the specified fluid must be added.
2. Remove the fill cap from the reservoir.
NOTE: The fill cap is vented.
a
Page 60
Description
b
Where Used
Power trim pump
b
7701
Nm lb–in.
6.8 60
7876
92-858074K01
Power trim pump reservoir shows the
fluid level is below "MIN" line
a - Fill cap assembly
b - Fill cap installed
90-8M0069751
eng
lb–ft
–
Part No.
APRIL 2012