Bravo Diesel Sterndrive Propeller Installation; Bravo One Models - Mercury Sterndrive QSD 2.0 Manual

Section 5 - Maintenance
7. Slide the propeller and the thrust hub off the propeller shaft.
b
a
i
j
g h

Bravo Diesel Sterndrive Propeller Installation

Rotating propellers can cause serious injury or death. Never operate the boat out of the water with a propeller installed.
Before installing or removing a propeller, place the drive unit in neutral and engage the lanyard stop switch to prevent the
engine from starting. Place a block of wood between the propeller blade and the anti‑ventilation plate.

Bravo One Models

IMPORTANT: Use the correct rotation propeller. The propeller rotation MUST match the direction of rotation of the propeller
shaft.
1. Liberally coat the propeller shaft spline with one of the following Quicksilver lubricants.
Tube Ref No.
Special Lubricant 101
34
2-4-C Marine Lubricant
95
with PTFE
Anti-Corrosion Grease
94
NOTE: Anti‑corrosion grease is for saltwater applications only.
2. Install the propeller with the attaching hardware as shown.
Page 102
e
f
d
c
!
a - Wood block
b - Propeller
c - Propeller nut under socket
Description
Bravo Three
a -
b -
c -
d -
e -
f -
g -
h -
i -
j -
5304
WARNING
Where Used
Propeller shaft splines
Propeller shaft splines
Propeller shaft splines
Aft propeller nut
Aft propeller
Aft propeller thrust hub
Front propeller nut
Front propeller
Front propeller thrust hub
Propeller shaft anode screw
Flat washer
Star washer
Propeller shaft anode
92-802865Q02
92-802859A 1
92-802867Q 1
90-8M0069751
eng
Part No.
APRIL 2012