Section 5 - Maintenance
4.
Ensure that the rubber gasket is inside the gear lube monitor cap and install the cap. Do not overtighten.
a
NOTE: When filling the entire sterndrive, Refer to Changing .
Changing
1.
Remove the gear lube monitor from the bracket.
b
a
2.
Empty the contents into a suitable container.
3.
Install the gear lube monitor in the bracket.
4.
Place the sterndrive in full trim limit out position, remove the gear lube fill and drain screw and sealing washer and drain the
gear lube.
b
a
5.
Remove the gear lube vent screw and sealing washer. Allow the gear lube to drain completely.
b
a
Page 54
a -
Gear lube monitor cap
19962
25339
a -
Gear lube fill and drain screw
b -
Sealing washer
7160
7161
a -
Retaining bracket
b -
Gear lube monitor
a -
Gear lube vent screw
b -
Sealing washer
90-8M0069751
APRIL 2012
eng