Table of Contents
Advertisement
8.
Install a fully charged battery. Clean the battery cable clamps and terminals. Reconnect the cables (refer to the CAUTION
listed above). Secure each cable clamp when connecting. Coat terminals with a battery terminal anti‑corrosion spray to
help retard corrosion.
9.
Perform all checks in the Starting Procedure column found in the Operation Chart. Refer to the On the Water section.
Without sufficient cooling water, the engine, the water pump, and other components will overheat and suffer damage. Provide
a sufficient supply of water to the water inlets during operation.
10. Supply cooling water to the water inlet openings.
11. Start the engine and closely observe instrumentation. Ensure that all systems are functioning correctly.
12. Carefully inspect the engine for fuel, oil, fluid, water, and exhaust leaks.
13. Check the steering system, shift, and throttle control for proper operation.
90-8M0069751
APRIL 2012
eng
NOTICE
Section 6 - Storage
Page 113
Advertisement
Table of Contents
