Table of Contents
Advertisement
Section 5 - Maintenance
c.
Drain the gear lube into a suitable container.
Bravo Two
a -
Fill and drain plug
b -
Sealing washer
7.
Remove the vent plug and sealing washer. Allow the gear lube to drain completely.
b
a
IMPORTANT: If any water drains from the fill and drain plug hole, or if the gear lube appears milky, the sterndrive is
leaking and should be checked immediately by your Mercury Diesel authorized repair facility.
8.
Lower the sterndrive so that the propeller shaft is level.
9.
Fill the sterndrive through the fill and drain plug hole with the specified gear lube until an air‑free stream of lube flows from
the vent plug hole.
Tube Ref No.
High Performance Gear
87
Lube
IMPORTANT: Use only Mercury/Quicksilver High Performance Gear Lube in the sterndrive.
10. Install the vent plug and sealing washer.
11. Continue to pump gear lube into the drive through the fill and drain plug hole until the gear lube appears in the gear lube
monitor.
Page 58
b
a
14621
19066
Description
Bravo Three
a -
Vent plug
b -
Sealing washer
Where Used
Sterndrive unit
b
a
19777
Part No.
92-858064K01
90-8M0069751
APRIL 2012
eng
Advertisement
Table of Contents
