Agilent Technologies 16718A Help Volume page 77

Chapter 2: Task Guide
To select transitional timing or store qualified
you want to send e-mail on.
A yellow box appears around the level.
2. Select the Trigger or Goto button and choose the Trigger, send e-mail,
and fill memory action.
3. Select the E-mail Setup button.
4. In the E-mail Setup dialog, enter the name of the SMTP (see page 76) mail
server (if you don't know this, contact your System Administrator), the
recipient's e-mail address (use spaces to separate multiple addresses), and
the text of the message.
If you want e-mail to be sent on each trigger of a repetitive run, select the
Send e-mail on repetitive run check box.
5. Select the OK button.
Note that the e-mail is sent when the trigger occurs and not after the
logic analyzer's acquisition memory is full.
You only need to specify one send e-mail action per trigger sequence.
As long as one trigger action sends e-mail, any trigger in the sequence
will result in e-mail being sent. (You cannot specify different send e-
mail setups in a trigger sequence.)
If the SMTP server has a problem with the default sender address
• You may need to specify a sender address that is recognizable by the
server. A possible address might be the one specified in the To: field.
Message Format
The automatically generated text is shown as follows:
Example: system14 : Slot C : Analyzer C has triggered
Where system14 is the analysis system IP address or alias you have
assigned to it; Slot C is the frame slot the module is in; Analyzer C
identifies the specific analyzer module from others when configured in
a multi-module frame configuration.
Any text you add in the text entry area of the e-mail setup dialog will
appear after the automatically generated text.
What is SMTP? SMTP (Simple Mail Transfer Protocol) is a TCP/IP
76
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com