Agilent Technologies 16718A Help Volume page 103

Chapter 2: Task Guide
Using Symbols
section will be read completely. This can occur if the file was created
without a "generate debugger information" flag (usually -g). Using the -
g will create a Dwarf or Stabs debug section in addition to the ELF
section.
StabsType
StabsType=0
StabsType=1
StabsType=2
ReadOnlyTicoffPage
ReadOnlyTicoffPage tells the ticoff reader to read only the symbols
associated with the specified page (as an example
'ReadOnlyTicoffPage=0' reads only page 0 symbols). A value of -1 tells
the ticoff readers to read symbols associated with all pages.
ReadOnlyTicoffPage=-1 Read all symbols associated will all
ReadOnlyTicoffPage=p
AppendTicoffPage
AppendTicoffPage tells the ticoff reader to append the page number to
the symbol value. This assumes that the symbol value is 16-bits wide
and that that page number is a low positive number which can be ORed
into the upper 16 bits of an address to create a new 32-bit symbol
address. For example, if the page is 10 decimal and the symbol address
is 0xF100 then the new symbol address will be 0xAF100.
AppendTicoffPage=1
AppendTicoffPage=0
Examples Example for Elf/Stabs
[ReadersElf]
C
102
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Reader will determine stabs type (Default)
Older style stabs
(Older style stabs have individual symbol
tables for each file that was linked into
the target executable, the indexes of each
symbol table restart at 0 for each file.)
Newer style stabs
(New style stabs have a single symbol table
where all symbols are merged into a large
symbol array).
ticoff pages (Default)
Read only symbols associated with
page 'p' (where p is any integer
between 0 and n the last page of
the object file).
Append the ticoff page to the symbol
address
Do not append the ticoff page to the
symbol address (Default)