Garmin G950 Pilot's Manual page 480

APPENDIX B
The Display Database Softkey (Figure B-11) is used to place the cursor in the Database Window. Upon
first press of the Display Database Softkey, the softkey will change to a selected state (black text on gray
background) and the cursor will appear in the Database Window. At this point the user can scroll through
all databases in the Database Window to view status information. If the Display Database Softkey is pressed
repeatedly, the softkey will switch between the PFD and MFD. Database status information in the Database
Window will reflect the database of the selected display. After a successful sync and restart, verify that the
proper databases are now in use on the AUX–System Status Page (Figure B-8).
If an error occurs during the synchronization, an error message will be displayed, followed by the affected
display in the Sync Status section of the Database Window (Figure B-9). If a synchronization completes on
one display, but an error occurs on another, the error message will be displayed with the affected diaplay
listed after it. When an error message (Table B-1) is displayed, the problem must be corrected before the
synchronization can be completed. A power cycle is required to restart synchronization when 'Card Full' or
'Err' is shown.
Error Message
Canceled
Card Full
Err
Timeout
468
'Card Full' Message
Figure B-9 Synchronization Error Message
Database synchronization has been canceled by removing the bottom SD card in
display being updated
SD card does not contain sufficient memory
Displayed for all other errors that may cause the synchronization process to be halted
System timed-out prior to the database transfer completing
Table B-1 Database Synchronization Error Messages
Garmin G950 Pilot's Guide for the Pilatus PC-6
Description
190-00870-02 Rev. A