Garmin G950 Pilot's Manual page 316

HAZARD AVOIDANCE
3) Turn the small FMS Knob to place the Bearing Line in the desired position. The location of the Bearing Line
becomes the center point of the Sector Scan.
4) Turn the large FMS Knob to place the cursor in the SECTOR SCAN field.
5) Turn the small FMS Knob to select FULL, 60˚, 40˚, or 20˚ scan.
6) If desired, readjust the Bearing Line as discussed previously to change the center of the Sector Scan.
7) Press the BRG Softkey again to remove the Bearing Line and cursor. The bearing reference resets to 0º.
a s
ntenna taBilization
When radar stabilization is active, the radar tilt is corrected for pitch and roll, and therefore is kept steady
with respect to an earth fixed reference. The commanded tilt angle is kept constant with respect to the
earth. When the stabilization is disabled, corrections are no longer made for pitch and roll, and the radar
tilt angle is kept constant with respect to the aircraft reference system.
304
Figure 6-16 Selecting Sector Scan Position
Figure 6-17 40˚ Sector Scan
Garmin G950 Pilot's Guide for the Pilatus PC-6
190-00870-02 Rev. A