Garmin G950 Pilot's Manual page 326

HAZARD AVOIDANCE
If heading input is lost, strikes and/or cells must be cleared manually after the execution of each turn
(Figure 6-25). This is to ensure that the strike and/or cell positions are depicted accurately in relation to the
nose of the aircraft.
Manually clearing Stormscope data on the Navigation Map:
1) Press the MENU Key.
2) Select 'Clear Stormscope
3) Press the ENT Key.
ZOOM RANGE ON THE NAVIGATION MAP
Stormscope lightning data can be displayed up to 800 nm zoom range (in North up mode) on the Navigation
Map Page. However, in the track up mode at the 500 nm range, a portion of Stormscope lightning data
can be behind the aircraft and therefore not visible on the Navigation Map. Since the range for Stormscope
data is 400 nm diameter total (200 nm in front and 200 nm behind), the 500 nm range in North up mode
shows all the data.
At a map range of less than 25 nm, Stormscope lightning data is not displayed, but can still be present.
The maximum zoom range can also be set on the Navigation Map. Note that Stormscope data above the
selected maximum zoom range is decluttered.
Selecting a Stormscope range on the Navigation Map:
1) Press the MENU Key.
2) Select 'MAP SETUP'.
3) Select the 'Weather' group.
4) Press the ENT Key.
5) Turn the large FMS Knob to select 'STRMSCP SMBL'.
6) Turn the small FMS Knob to select the maximum display range.
7) Press the ENT Key.
8) Press the FMS Knob to return to the Navigation Map Page.
To change the display range on the Navigation Map Page, turn the Joystick clockwise to zoom out or
counter-clockwise to zoom in.
314
Lightning'.
®
Figure 6-25 Navigation Map Page Options Menu
Garmin G950 Pilot's Guide for the Pilatus PC-6
190-00870-02 Rev. A