Garmin G950 Pilot's Manual page 35

Integrated avionics system for pilatus pc-6
Hide thumbs Also See for G950:
Table of Contents

Advertisement

HSI FRMT
360 HSI
ARC HSI
BRG2
ALT UNIT
METERS
IN
HPA
STD BARO
OBS
CDI
DME
XPDR
STBY
ON
ALT
GND
VFR
CODE
0 — 7
BKSP
IDENT
TMR/REF
NRST
ALERTS
190-00870-02 Rev. A
OFF
DCLTR
Displays the softkeys for selecting the two HSI formats
Displays HSI as a 360° compass rose
Displays HSI as a 140° viewable arc
Cycles the Bearing 2 Information Window through NAV2 or GPS waypoint identifier and
GPS-derived distance information, and ADF/frequency.
Displays softkeys for setting the altimeter and BARO settings to metric units
When enabled, displays altimeter in meters
Press to display the BARO setting as inches of mercury
Press to display the BARO setting as hectopacals
Sets barometric pressure to 29.92 in Hg (1013 hPa if metric units are selected)
Selects OBS mode on the CDI when navigating by GPS (only available with active leg)
Cycles through GPS, VOR1, and VOR2 navigation modes on the CDI
Displays the DME Tuning Window, allowing tuning and selection of the DME (optional)
Displays transponder mode selection softkeys
Selects standby mode (transponder does not reply to any interrogations)
Selects Mode A (transponder replies to interrogations)
Selects Mode C – altitude reporting mode (transponder replies to identification and
altitude interrogations)
Manually selects Ground Mode, the transponder does not allow Mode A and Mode C
replies, but it does permit acquisition squitter and replies to discretely addressed Mode S
interrogations
Automatically enters the VFR code (1200 in the U.S.A. only)
Displays transponder code selection softkeys 0-7
Use numbers to enter code
Removes numbers entered, one at a time
Activates the Special Position Identification (SPI) pulse for 18 seconds, identifying the
transponder return on the ATC screen
Displays Timer/References Window
Displays Nearest Airports Window
Displays Alerts Window
INSET
PFD
OBS
Figure 1-16 Top Level PFD Softkeys
INSET
Garmin G950 Pilot's Guide for the Pilatus PC-6
TOPO
(optional)
CDI
DME
XPDR
IDENT
Press the CDI Softkey to cycle through
navigation sources:
- GPS
- NAV1 (VOR/LOC)
- NAV2 (VOR/LOC)
(if installed)
TERRAIN STRMSCP
SYSTEM OVERVIEW
TMR/REF
NRST
ALERTS
BACK
ALERTS
23

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents