Bearing Line
4) Press the VERTICAL Softkey. A vertical slice of the selected area is displayed (Figure 6-13).
5) The small FMS Knob may be used to move the scanned slice a few degrees right or left.
6) Turn the Joystick to adjust the range.
7) Press the FMS Knob to remove the cursor.
8) To select a new area to be vertically scanned, press the HORIZON Softkey to return to the Horizontal Scan view
and repeat the previous steps.
The Joystick can also be used to adjust bearing from left to right.
190-00870-02 Rev. A
Figure 6-12 Bearing Line on Horizontal Scan
Figure 6-13 Vertical Scan Display
Garmin G950 Pilot's Guide for the Pilatus PC-6
HAZARD AVOIDANCE
Scan Line
301