Garmin G950 Pilot's Manual page 467

Message
UNABLE V WPT – Can't reach current
vertical waypoint.
VNV – Unavailable. Unsupported leg
type in flight plan.
VNV – Unavailable. Excessive
crosstrack error.
VNV – Unavailable. Excessive track
angle error.
VNV – Unavailable. Parallel course
selected.
NON WGS84 WPT – Do not use GPS
navigation to [xxxx].
TRAFFIC FAIL – Traffic device has
failed.
FAILED PATH – A data path has failed. A data path connected to the GDU or the GIA 63/W has failed.
MAG VAR WARN – Large magnetic
variance. Verify all course angles.
SCHEDULER [#] – <message>.
CHECK CRS – Database course for
LOC1 / [LOC ID] is [CRS]°.
CHECK CRS – Database course for
LOC2 / [LOC ID] is [CRS]°.
[PFD1, or MFD1] CARD 1 REM –
Card 1 was removed. Reinsert card.
[PFD1, or MFD1] CARD 2 REM –
Card 2 was removed. Reinsert card.
[PFD1, or MFD1] CARD 1 ERR – Card
1 is invalid.
[PFD1, or MFD1] CARD 2 ERR – Card
2 is invalid.
190-00870-02 Rev. A
Comments
The current vertical waypoint can not be reached within the maximum flight path
angle and vertical speed constraints. The system automatically transitions to the next
vertical waypoint.
The lateral flight plan contains a procedure turn, vector, or other unsupported leg
type prior to the active vertical waypoint. This prevents vertical guidance to the active
vertical waypoint.
The current crosstrack exceeds the limit, causing vertical deviation to go invalid.
The current track angle error exceeds the limit, causing the vertical deviation to go
invalid.
A parallel course has been selected, causing the vertical deviation to go invalid.
The position of the selected waypoint [xxxx] is not calculated based on the WGS84
map reference datum and may be positioned in error as displayed. Do not use GPS to
navigate to the selected non-WGS84 waypoint.
The system is no longer receiving data from the traffic system. The traffic device
should be serviced.
The GDU's internal model cannot determine the exact magnetic variance for
geographic locations near the magnetic poles. Displayed magnetic course angles may
differ from the actual magnetic heading by more than 2°.
Message criteria entered by the user.
Selected course for LOC1 differs from published localizer course by more than 10
degrees.
Selected course for LOC2 differs from published localizer course by more than 10
degrees.
The SD card was removed from the top card slot of the PFD or MFD. The SD card
needs to be reinserted.
The SD card was removed from the bottom card slot of the PFD or MFD. The SD card
needs to be reinserted.
The SD card in the top card slot of the PFD or MFD contains invalid data.
The SD card in the bottom card slot of the specified PFD or MFD contains invalid data.
Garmin G950 Pilot's Guide for the Pilatus PC-6
APPENDIX A
455