Table of Contents
Advertisement
Chapter 2 Preparation
2.1 Operating Environment
The scanner requires a host computer equipped with a USB port (Version 1.1 or later). The operating environment differs
depending upon whether you use the USB keyboard interface or USB-COM interface as listed below.
USB keyboard interface:
No dedicated USB device driver is required. Via this interface, data scanned by the scanner can be entered to the cursor
position in your application. For instructions how to set up the device driver, refer to Chapter 3, Section 3.1. For the
interface specifications, refer to Chapter 11, Section 11.1.
This interface is selected by default.
USB-COM interface:
To use this interface, you need to install the dedicated USB-COM device driver (virtual COM port driver) to the host
computer. This interface allows you to use the scanner in applications using the conventional serial port. For instructions
how to set up the device driver, refer to Chapter 3, Section 3.2. For the interface specifications, refer to Chapter 11,
Section 11.2.
You can switch between the USB keyboard interface and USB-COM interface by using the bar-coded parameter menu
(provided in Chapter 13) or the configuration software*.
Host computer
Operating System (OS)
USB driver
Note: The scanner cannot be used on Windows NT that does not support any USB device.
* The configuration software (ScannerSetting) is available as free downloads from our website at
http://www.denso-wave.com/.
To use the USB keyboard
interface (factory default):
PC/AT or AT/AT compatible PC including NEC PC98-NX,
Windows 98/98SE
Windows XP Home/Professional
OS-supplied device driver
2
To use the USB-COM interface:
equipped with a USB port
Windows 98SE
Windows Me
Windows 2000 Professional
USB-COM device driver
provided by DENSO WAVE
Advertisement
Table of Contents
