Table of Contents
Advertisement
Preparation
Follow the steps below to prepare the BHT for use.
Step 1 Charging (Page 16)
Step 2 Attaching the Stylus (Page 21)
Step 3 Turning ON the Power (Page 22)
Step 1 Charging
The BHT battery is not charged when purchased and must therefore be charged prior
to use.
The following chargers can be used with the BHT.
Communication units:
CU-733, CU-714
Battery chargers:
CH-751, CH-704
*
The CH-704 charger is used for charging individual batteries, and the CH-751 is a
stand-type (same type as CU (communication unit) charger.)
The charge time is approximately 3 hours (standard rechargeable
battery cartridge) or 6 hours (large-capacity rechargeable battery
cartridge).
• An almost completely discharged battery cartridge should take this time to become
fully charged.
Charging Precautions
●
Do not touch the BHT, battery, or charger terminals by hand or stain them. Doing so
could result in a contact failure or prevent charging.
●
Never charge the battery near fire or in a high-temperature environment.
High-temperatures may activate the charger's protective device, preventing charging,
and lead to protective device damage, overheating, blowout or combustion.
●
Terminate charging if not completed even after the specified time has elapsed.
First charge the battery.
Attach
prevent it from being
lost.
Preparation
complete.
16
the
stylus
to
is
now
Advertisement
Table of Contents
