Denso GT10B-SU User Manual page 53

Codabar (NW-7)
Start code
The bar code symbology may or may not contain a check digit. You can select whether or not to read a check digit and
transmit the check digit read. There are two check digit methods available: modulo arithmetic-16 (MOD-16) and -7
(MOD-7).
You can also select whether or not to transmit start/stop codes, as well as selecting either lowercase letters "a/b/c/d" or
uppercase letters "A/B/C/D" for start/stop codes.
Code 39
Start code
The bar code symbology may or may not contain a check digit. You can select whether or not to read a check digit and
transmit the check digit read.
You can also select whether or not to transmit start/stop codes (which are "*") and enable conversion to Code 39 FULL
ASCII.
Code 93, Code 128, EAN-128
When Code 128 is specified, data in the following format is regarded as an EAN-128 code.
Start code
If data contains FNC1, you may select whether or not to convert the FNC1 to GS (1Dh) and transfer.
MSI, Plessey
GTIN
When conversion to the GTIN format is enabled, the following formats apply.
UPC-A 01
UPC-E 01
EAN-13 01
EAN-8 01
ITF-14 01
01
UPC-E code data is converted to the ZERO insertion format and then to the GTIN format.
In the case of ITF symbology, conversion to the GTIN format applies to 14-digit data. Other number of digits of data is
transmitted in the original format.
Data
Data
Data
FNC1
Data C/D
0 0
0 0
0 Data (12-digit)
00000
Data (13-digit)
C/D Stop code
C/D Stop code
Data C/D
Data (11-digit)
Data (11-digit)
Data (7-digit)
Data (14-digit)
44
Stop code
C/D
C/D
C/D
C/D
C/D
(C/D: Check digit)