Denso GT10B-SU User Manual page 56

(3) Communications parameters for USB-COM interface
The following settings take effect only when the USB-COM interface is set up.
Items
Communications protocol
CTS signal monitor
Header
Terminator
CTS signal timeout
ACK/NAK response time
(4) Data transmission format and bar code symbologies
Items
Prefix transmission
Suffix transmission
Data editing
Transmission of code ID mark
Code ID mark position
Code ID mark
Transmission of the number of digits
(not applicable to UPC/EAN codes)
Conversion to GTIN format
Parameters
Non-acknowledge mode
ACK/NAK mode
Enable
Disable
None
STX
ETX
CR
LF
CR LF
0.1 to 9.9 s
0.1 to 9.9 s
Parameters
Enable
Disable
Enable
Disable
Enable
Disable
Enable
Disable
Before prefix
After prefix
Type1 (DENSO 1)
Type2 (DENSO 2)
Type3
Type4
Type5 (AIM)
Enable, in 4 digits
Enable, in 2 digits
Disable
Enable
Disable
: Can be changed only with the configuration software.
47
Defaults Refer to:
√
Section 11.2 (1)
Section 11.2 (2)
√
√
Section 11.3 (1)
√
0.2 s
Section 11.2 (1)
1 s
Defaults Refer to:
√
Section 11.3 (2)
√
Chapter 9
√
√
√
√
Section 11.3 (3)
Section 11.3 (4)
√
Section 11.3 (5)
√