Chapter 2 Preparation - Denso GT10Q-SR Operator's Manual

Chapter 2 Preparation

Connecting the interface cable to the scanner
(1) Pull the connector cover of the interface cable off its connector as shown below.
(2) Plug the cable connector into the connector located in the bottom of the scanner.
NOTE: As shown below, hold the scanner body, align the
connector with that on the scanner, and fully insert the interface connector.
Interface connector
Connector cover
(3) Align the two bosses on the connector cover with cutouts in the scanner body, fit the
connector cover into the scanner, and turn it clockwise to lock it.
Scanner
mark
▼
Cutout
Boss
Connector cover
2
mark on the cable
▼
mark
▼
Connector cover
Turn the cover until the
bosses come to be
horizontal.