Table of Contents
Advertisement
When copying driver files is finished, "New hardware found" messages for "Unknown device" and "DENSO WAVE
USB-COM Port" appear in this order.
All installation processes are completed.
(7) To make sure that the USB-COM device driver has been successfully installed, open the Windows' Device Manager.
If DENSO WAVE USB-COM Port is added to the sub-tree of Ports (COM & LPT) as shown below, the scanner
is connected normally.
If the device is not added or it is marked with
and perform the above connection process again.
Windows 2000
(1) Switch the computer on to run Windows 2000. Log on as an Administrator.
(2) Connect the scanner to the computer or USB hub, and the following message appears meaning that the "USB Device
GT10B-SU/LU" has been found.
or
, remove this driver with the uninstaller, reboot your computer,
15
Advertisement
Table of Contents
