Moving And Transporting The Machine - Ricoh SP 330DN Service Manual

Installation Requirements

2.1.3 MOVING AND TRANSPORTING THE MACHINE

•
It is dangerous to handle the power cord plug with wet hands. Doing so could result in
electric shock.
•
Unplug the power cord from the wall outlet before you move the machine. While
moving the machine, take care that the power cord is not damaged under the machine.
Failing to take these precautions could result in fire or electric shock.
•
When disconnecting the power cord from the wall outlet, always pull the plug, not the
cord. Pulling the cord can damage the power cord. Use of damaged power cords could
result in fire or electric shock.
•
The printer weighs approximately 17.5 kg (38.6 lb.). When moving the printer, use the
inset grips on both sides, and lift slowly. The printer will break or cause injury if
dropped.
•
When moving the printer after use, do not take out the toner bottle or the waste toner
bottle, to prevent toner spill inside the printer.
•
Do not hold the control panel while moving the printer. Doing so may damage the
control panel, cause a malfunction, or result in injury.
Be careful when moving the printer. Take the following precautions:
•
Turn off the main power.
•
Close all covers and trays, including the front cover and bypass tray.
•
If optional paper feed units are attached, remove them from the printer and move them
separately.
•
Be sure to place the printer on a smooth and stable place.
•
Keep the printer level and carry it carefully, taking care not to shake or tilt it. Rough
handling may cause a malfunction or damage the hard disk or memory, resulting in
loss of stored files.
M0C3/M0C4/M0C5/M0C6/M0C7 2-2 SM