Maintenance Mode (for Touch Panel Models)
Print Reports
Menu
G3 Protocol dump list
CTL SP
Menu
Air Print
Sets whether the Air Print function is enabled or disabled.
Enable
[Disable/ Enable (Default)]
Debug
[Off (Default)/ NIC/ USB]
Tools
Disable
Sets the USB port function is valid or invalid
USB Port
[Off (Default)/On]
Pas
When used to set Paas (Only for CHN)
Validity
[Inactive (Default)/ Active]
Setting
PDL Mode
ON = "PDL Settings" is shown in [Print List/Report] menu (Default)
OFF = "PDL Settings" is hidden
FW Update
If updating the firmware for a machine in which LDAP authentication is set, execute
Mode
this mode.
[Execute/ Return]
After pressing "Execute", the display shows "Please Restart Machine...." Turn the
machine's main power off, and then on. Then the machine activates in a special
boot loader mode. After that, update the firmware via USB cable.
Auto IP
ON = Automatically set the IP address when the IP address cannot be acquired
(Default)
OFF = Continually try to obtain the IP address by DHCP
Factory Default
Menu
Factory
Return
Default
Execute Resets all the settings to factory default.
M0C3/M0C4/M0C5/M0C6/M0C7
G3 protocol dump of the latest communication is printed.
Off (Default)/ Error/ On
Does not execute anything. Returns to an upper level.
Description
Description
Description
5-26
SM