Ricoh SP 330DN Service Manual page 141

Menu
Horiz Bypass
tray
Vert Bypass
Plain
Vert Bypass
Thick
Vert Bypass
Thin
Horiz. Dup.
Back
Vert Dup
Plain
Vert Dups
Thick
Vert Dup Thin [-40.0 to 40.0 / 21.0 (Default) / 0.1 mm/step]
Destination
Test Pattern
Toner Disposal
1200DPI Power
Refill Mode
Page Dot 0%-2%
Coverage
3%-4%
SM
Maintenance Mode (for Four-line LCD Models)
[-40.0 to 40.0 / -7.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 23.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 23.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 23.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 21.0 (Default) / 0.1 mm/step]
[-40.0 to 40.0 / 21.0 (Default) / 0.1 mm/step]
DFU
Sets the destination and updates the engine setting.
[DOM/ NA/ EU/ ASIA/ CHN/ TAIWAN]
Prints the test pattern.
Sets the machine operation at "waste toner full" of the refilled
AIO.
[On or Off (Default)]
With the main motor rotation count feature, the machine can be
set to stop printing after the print total exceeds a certain set
value. If the print count exceeds this value, then "Replace Print
Cartridge" remains in the display. Then a new AIO cartridge
must be installed. This feature is a safety measure to prevent the
used toner tank from becoming full (there is no toner overflow
detection mechanism).
Adjusts print density (density levels by increasing the number)
[42 to 106 / 74 (Default) / 1 /step]
DFU
[Auto refill mode/ Pure refill mode]
Displays the number of pages printed with coverage 0 to 2%.
Displays the number of pages printed with coverage 3 to 4%.
5-7
Description
M0C3/M0C4/M0C5/M0C6/M0C7