Factory Default; Ctl Maintenance - Ricoh SP 330DN Service Manual

Menu
Flatbed Main Reg.
Flatbed Sub Reg.

Factory Default

Menu
Factory Return
Default
Execute Resets all the settings to factory default.

CTL Maintenance

Menu
PDL Mode
ON = "PDL Settings" is shown in [Print List/Report] menu (Default)
OFF = "PDL Settings" is hidden
FW Update
If updating firmware on a machine in which LDAP authentication is set, execute this
Mode
mode.
[Execute/ Return]
After pressing "Execute", the display shows "Please Restart Machine...." Turn the
machine's main power off, and then on. Then the machine activates in a special
boot loader mode. After that, update the firmware via USB cable.
Auto IP
ON = Automatically set an IP address when an IP address cannot be acquired
(Default)
OFF = Continually try to obtain an IP address by DHCP
Disable
Sets whether the USB port function is valid or invalid
USB Port
[Off (Default)/On]
Paas
When used to set Paas (Only for CHN)
Validity
[Inactive (Default)/ Active]
Setting
SM
[-0.9 to 0.9 / 0 (Default)/ 0.1 %/step]
Adjusts the Flatbed Scan main-scan magnification.
[-0.9 to 0.9 / 0 (Default)/ 0.1 %/step]
Adjusts the Flatbed Scan sub-scan magnification.
[-0.9 to 0.9 / 0 (Default)/ 0.1 %/step]
Does not execute anything. Returns to an upper level.
Clears/ resets the contents of the controller memory (all data
programmed by the user, log data application counters) to factory default.
After executing, initial setup menu starts after power-on.
5-9
Maintenance Mode (for Four-line LCD Models)
Description
Description
Description
M0C3/M0C4/M0C5/M0C6/M0C7