NETGEAR WAX610 User Manual page 191

Insight Managed WiFi 6 AX1800 Dual Band Access Point WAX610 User Manual
To set up a WiFi bridge between two access points:
1. Open a web browser from a computer that is connected to the same network as the
access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
A login window opens.
If your browser does not open the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 37.
3. Enter the access point user name and password.
The user name is admin. The password is the one that you specified. The user name
and password are case-sensitive.
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight app or Insight Cloud portal, enter the
Insight network password for that location. For more information, see Connect over
WiFi using the NETGEAR Insight app on page 22.
The Dashboard page displays.
4. Select Management > Configuration > Wireless Bridge.
The page that displays lets you select a WDS profile (WDS 1, WDS 2, WDS 3, or WDS
4).
5. Click the > button to the left of a WDS profile.
The WDS profile page displays.
6. Select the Band 2.4 GHz or 5 GHz radio button.
Your selection determines the radio band on which the WDS is established. For
countries that do not support dual-band operation, you cannot select the radio.
7. Select the VAP Enable radio button.
By default, a WDS profile is disabled.
Set up a WiFi Bridge 191 User Manual