NETGEAR WAX610 User Manual page 166

Insight Managed WiFi 6 AX1800 Dual Band Access Point WAX610 User Manual
To enable or disable the LEDs:
1. Open a web browser from a computer that is connected to the same network as the
access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
A login window opens.
If your browser does not open the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 37.
3. Enter the access point user name and password.
The user name is admin. The password is the one that you specified. The user name
and password are case-sensitive.
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight app or Insight Cloud portal, enter the
Insight network password for that location. For more information, see Connect over
WiFi using the NETGEAR Insight app on page 22.
The Dashboard page displays.
4. Select Management > Configuration > System > Advanced > LED Control.
The LED Control page displays.
5. Select one of the following radio buttons:
• Enable All LEDs. All LEDs are enabled. This is the default setting.
• Disable All LEDs. All LEDs are disabled.
• Enable Power/Cloud LED. All LEDs are disabled except for the Power/Cloud
LED.
6. Click the Apply button.
Your settings are saved.
Manage and Maintain the Access
Point
166 User Manual