View The Wifi Radio Settings - NETGEAR WAX610 User Manual

Insight Managed WiFi 6 AX1800 Dual Band Access Point WAX610 User Manual
- Current Time. The current system time of the access point.
- Uptime. The time since the access point was last restarted.
• AP Interface Status. A green icon indicates that the interface is in use. A gray
icon indicates that the interface is not in use.
• IPv4 Settings section. The following settings are displayed:
- IPv4 Address. The IPv4 address of the access point.
- Subnet Mask. The subnet mask of the access point.
-
Default Gateway. The default gateway for the access point.
- DHCP Client. The status of DHCP client (Enabled or Disabled).
• Wireless Settings section. The following settings are displayed, with separate
columns for the 2.4 GHz and 5 GHz radios:
- Antenna. The type of antenna (by default, 2x2).
- Wireless Mode. The operating WiFi mode of the radio.
- Channel / Frequency. The channel and frequency that are used by the radio.

View the WiFi radio settings

To view the WiFi radio settings of the access point:
1. Open a web browser from a computer that is connected to the same network as the
access point or directly to the access point through an Ethernet cable or WiFi
connection.
2. Enter the IP address that is assigned to the access point.
A login window opens.
If your browser does not open the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 37.
3. Enter the access point user name and password.
The user name is admin. The password is the one that you specified. The user name
and password are case-sensitive.
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight app or Insight Cloud portal, enter the
Monitor the Access Point and the
Network
171 User Manual