Samsung MT3204 Series Installation Manual page 119

Appendix B
Introduction
When connecting an optical cable to the system, the performance of the system
can be decreased or failures can occur if the core section of an optical connector is
dirty due to dust or foreign material. Therefore, operator should clean the optical
connector before connecting an optical cable to the system.
When using an optical connector cleaner, use the products shown in the example
below or their equivalents.
Examples:
Manufacturer-USCONEC (http://www.usconec.com)



Manufacturer-The Fibers (www.thefibers.com)


Follow the manufacturer's instructions for cleaning the optical connectors.
Measure the Optical Output and Connecting the Optical Connector
1
MT3204 Series Installation Manual v1.0
Copyright © 2018, All Rights Reserved.
IBC TM Brand Cleaner (P/N: 9393): For LC-LC and MU Connector Cleaning
IBC Brand Cleaner (P/N: 9392): For SC Connector Cleaning
TM
IBC TM Brand Cleaner (P/N: 12910): For ODC Connector Cleaning
HuxCleaner 1.25 mm Type: For LC and MU Connector Cleaning
HuxCleaner 2.5 mm Type: For SC, FC and ST Connector Cleaning
To measure the optical output
Using an optical power meter check the optical output.
Clean the Optical
Connectors
Confidential
104