Product Overview
Specifications
Traction-unit compatibility
Cutting width
Height-of-cut
Height-of-cut range
Reel bearings
Front roller
Bedknife
Bedknife adjustment
Grass shield
Counterweight
Net weight
Clip rate
Attachments/Accessories
A selection of Toro approved attachments and accessories is available for use with the machine to enhance
and expand its capabilities. Contact your Authorized Service Dealer or authorized Toro distributor or go to
www.Toro.com for a list of all approved attachments and accessories.
To ensure optimum performance and continued safety certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement parts and accessories made by other manufacturers could be
dangerous, and such use could void the product warranty.
Operation
Refer to your traction unit Operator's Manual for detailed operation instructions. Before using the cutting unit
each day, adjust the bedknife; refer to
test swath before using the cutting unit on a green to ensure that the finished cut is correct.
These cutting units mount on the appropriately-sized Greensmaster Flex or eFlex 1018 or
1021 traction units.
Model No. 04853 and 04854
46 cm (18 inches)
Adjust the front roller held by 2 vertical screws and nuts.
The standard bench height-of-cut range is 1.6 mm (0.062 inch) to 12.7 mm (0.500 inch).
The bench height-of-cut range with the High Height of Cut Kit installed is 7 mm (0.285 inch)
to 25 mm (1.00 inch). The effective HOC may vary depending on turf conditions, type of
bedknife, rollers, and attachments installed.
There are 2 sealed stainless steel, deep-groove ball bearings.
The front roller is 6.3 cm (2.5 inches) in diameter with a variety of configurations selected by
the customer.
This machine comes standard with an EdgeMax Microcut bedknife. Optional bedknives
with a variety of configurations are available. The bedknife is fastened to a machined,
cast-iron bedbar with 13 screws.
There is a dual-screw adjustment to the reel with detents corresponding to 0.018 mm
(0.0007 inch) bedknife movement for each indexed position.
The shield enhances grass discharge from the reel in wet conditions.
A cast-iron weight mounted opposite to the drive line balances the cutting unit.
Model No. 04853
Model No. 04854
34 kg (74 lb)
04854: 35 kg (77 lb)
Refer to your traction unit Operator's Manual.
Adjusting the Bedknife Daily (page
5
Model No. 04863, 04864
53 cm (21 inches)
Model No. 04863
Model No. 04864
35 kg (77 lb)
36 kg (80 lb)
7). Test the quality of cut by cutting a