Step 2.
Disassemble the system board.
Figure 192. Disassembling the system board
1. Remove the following screws as illustrated:
• Nine slotted screws (with PH2 screwdriver)
• Four guiding pin standoffs (with 6 mm wrench)
• One plunger (with 11 mm and 16 mm wrench)
• Eight T20 screws on the CPU sockets (with T20 screwdriver)
• Two hexagon bolts on VGA and COM (RS232) connectors (with 5 mm wrench)
2. Separate the components
After you finish
After disassembling the system board, comply with local regulations when recycling.
from the system board.
1 2 3 4 5 6 7
Appendix A. Hardware disassembling for recycle
437