Procedure
Step 1.
If the server is installed with the security bezel, remove it first. See "Remove the security bezel" on
page 362.
Step 2.
Use a flat-blade screwdriver to remove the ID label plate on the right rack latch and place it in a
safe place.
Figure 123. ID label plate removal
Step 3.
Disconnect the VGA cable , the front-I/O-assembly cable, or both cables from the system board.
Step 4.
Remove the screws that secure the cable retainer on the side of the server. Then, remove the cable
retainer from the chassis.
Figure 124. Cable retainer removal
.
Chapter 4
Hardware replacement procedures
279