Table of Contents
Advertisement
Procedure
Step 1.
Check your server and ensure that:
• All cables, adapters, and other components are installed and seated correctly and that you have
not left loose tools or parts inside the server.
• All internal cables are connected and routed correctly. See Chapter 3 "Internal cable routing" on
page 57.
Step 2.
A new top cover comes without sponges by default. If the old top cover is installed with sponges,
remove the sponges from the old top cover and attach them to the new top cover.
Figure 188. Remove the sponges from the old top
cover
Figure 189. Attach the sponges to the new top cover
.
Chapter 4
Hardware replacement procedures
395
Advertisement
Table of Contents
